Product: eSUN PLA Photopolymer Resin for LCD 3D printers, eResin-PLA

Size: 1000ml

Colour: Grey/White/Black/Beige

Compatible with our CREALITY3D LD002R resin 3d printers and other resin 3d printers. Packaged in a durable aluminium bottle

Parameters:

• Solidify wavelength: 395nm to 405nm
• Hardness (D): 75D
• Viscosity (25C,mPa.s): 200-300 mpa.s
• Density: 1.09 to 1.10 g/cm3
• Flexural strength (MPa): 36-49
• Tensile Strength(MPa): 37-48
• Impact Strength(J/m) 32-36
• Hardness (D): 78-80
• Elongation at Break(%): 25-28

Precautions:

1. Storage

1) Keep away from light and sealed at room temperature.

2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.

Avoid any dusty or moist environment.

2. Usage:

1) Shake well before use. Avoid any direct sunlight during usage.

2) Keep it away from the children. Do not put it in your mouth.

3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.

4) If accidentally contacted, please wash with plenty of water immediately. Seek medical advice if necessary.

5) Finished models are required to clean with high-concentration alcohol (>95%) for about 30 seconds.

Before choosing eSUN resins for your LCD 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible with Creality3D LD002R, EPAX X1, Anycubic Photon and Wanhao D7.

Bottom Exposure Time: 30-the 50s when the layer thickness is 0.05mm, recommend set to 40s.

Normal Exposure Time: 6-10s when the layer thickness is 0.05mm, recommend set to 7s on EPAX X1 or 10 seconds on Anycubic Photon.

PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness of 0.05mm。 if the thickness is 0.1mm, the normal exposure time will be 12-20s. If layer thickness is 0.02 then the normal exposure time is 2-4s.

We also offer bundle deals for this product

[Click here] to know more