Check out this video:

Imagine your self-printed masterpiece floating in the air - no tricks, just pure technology! The Magnetic Levitation Kit from Bambu Lab brings the wow effect directly to your desk. Whether it's a stylish moon lamp, collector's figure or your own 3D artwork: with the Levitation Kit, you can literally take your projects to a new level.

You can control the integrated LED light with a touch switch on the base - with three atmospheric colour modes: cool white, warm white and warm yellow. Thanks to electromagnetic induction, no batteries are required. Simply plug it in - without any tangled cables or power guzzlers. A 3D-printed protective cover ensures that your set is well protected even when it is first set up.

Tip: Your object remains suspended - until you touch it. The kit carries up to 200 g - so as long as the centre of gravity is correct, your model will hover as if by magic!

How to make your model float properly

Lower the float (or your 3D-printed model with the float) very slowly and carefully to the centre of the base. You will notice how the magnetic forces change. Does it pull in one direction or tilt? Then simply lift it up briefly, move it slightly and try again - at some point you will find the perfect spot and bang, it will float!

► Important: If you try too often and the base gets hot, the safety mode can kick in. Don't stress - just unplug it, leave it to cool down for 10-20 minutes and carry on with your work.

LED control via touch

You can easily control the LED light with the touch switch on the base - a gentle tap is all it takes. There are three light modes to choose from:

    Cold white - for a clean, futuristic look
    Warm white - cosy but modern
    Warm yellow - extra cosy and atmospheric

Included in delivery:

    1 x magnetic levitation base
    1 x magnetic levitation float
    1 x 12V 2A mains adapter (AC/DC) with interchangeable plug attachment

Downloads

   3D Model (12,50 MB)
   Design Guidelines (4,02 MB)
   Quick Start Guide (750,28 KB)