Bambu Lab 3508 Extruder Servo Motor for P2S 3D Printer [FAM018]

Bambu Lab 3508 Extruder Servo Motor for P2S 3D Printer [FAM018]

Name: Bambu Lab 3508 Extruder Servo Motor for P2S 3D Printer [FAM018]
Brand: Bambu Lab
SKU: FAM018
Price: 120 NZD
Availability: InStock

Review (0)

$120.00

Tax included

Auckland Local Stock.

Auckland Local Stock
Authorized NZ Distributor – Marvle3D

*3508 Extruder Servo Motor for P2S [FAM018]
-High-precision extruder servo motor
-Controls filament feeding and retraction
-Ensures accurate filament stopping
-Critical for consistent print quality
-OEM-developed motor by Bambu Lab

Compatible Printers: Bambu Lab P2S

Why Marvle3D?
Marvle3D—New Zealand’s expert since 2016, offering friendly support, in-store demos, and one of the country’s largest ranges.

Security policy(edit with the Customer Reassurance module)
Delivery policy(edit with the Customer Reassurance module)
Return policy(edit with the Customer Reassurance module)

Remove the Extruder Servo Motor
Step 1: Remove the Toolhead Housing
Please refer to the wiki: Replace the Toolhead Housing for instructions on removing the toolhead housing. https://wiki.bambulab.com/en/p2s/maintenance/replace-toolhead-housing

Step 2: Remove the Extruder
Please refer to the wiki: Replace extruder components for instructions on removing the extruder.

Step 3: Remove the TH board
Please refer to the wiki: Replace the Toolhead Circuit Board for instructions on removing the TH board. https://wiki.bambulab.com/en/p2s/maintenance/replace-th-boards-and-fpc-cable

Step 4: Remove the Extruder Servo Motor
Use an H2.0 Allen key to remove the two extruder servo motor fixing screws (M2.5x5), and then remove the 3508 extruder servo motor from the toolhead.

Install the Extruder Servo Motor
Step 1: Install the Extruder Motor
Refer to the installation orientation in the figure below (with the extruder servo motor cable facing left), and install the extruder servo motor onto the toolhead. Then, use an H2.0 Allen key to tighten the two M2.5×5 mounting screws.
Note: Please hold the extruder servo motor with your hand to prevent it from falling.