Overview:

When facing the printer's front door, the right side cover is referred to as the right side panel.

Removing the Right Side Panel
Step 1: Remove the PTFE Tube Bracket, Filament Buffer, and Rear Panel
Refer to the following Wiki disassembly guides to remove the PTFE tube bracket, filament buffer, and rear panel in sequence:
https://wiki.bambulab.com/en/p2s/maintenance/replace-ptfe-tube-bracket
https://wiki.bambulab.com/en/p2s/maintenance/replace-filament-buffer
https://wiki.bambulab.com/en/p2s/maintenance/replace-rear-panel

Step 2: Remove the Adaptive Airflow Switching Unit
You can refer to the instructions for Replacing Adaptive Airflow Switching Unit to remove the adaptive airflow switching unit.
https://wiki.bambulab.com/en/p2s/maintenance/replace-adaptive-airflow-switching-unit

Step 3: Remove the Screen and Front Cover
You can refer to the instructions for Replacing the Front Cover to remove the screen and front cover.
https://wiki.bambulab.com/en/p2s/maintenance/replace-front-cover

Step 4: Remove the Right Side Panel
A total of 19 screws secure the side panels.
Use tweezers or a knife to cut through the foam, then use an H1.5 Allen key to remove the three screws on the top of the right side panel.
Use a H2.0 Allen key to remove the five screws on the front column. Three are located in the gap of the silicone strip, and two are near the side screw.
Use an H2.0 Allen key to remove the two screws on the upper beam, one of which is covered with foam.
Use an H2.0 Allen key to remove the four screws on the back.
Use an H2.0 Allen key to remove the two screws on the right rear column.
Place the printer on its left side and use an H2.0 Allen key to remove the three screws at the bottom.
Set the printer upright and remove the right side panel.